Reactive ion etching of ZnO using the H2/CH4 and H2/CH4/Ar mixtures

Kuang Po Hsueh*, Ren Jie Hou, Cheng-Huang Kuo, Chun Ju Tun

*Corresponding author for this work

研究成果: Conference article

摘要

This work investigates the reactive ions etching (RIE) physical properties of n-type ZnO using H2/CH4 and H2/CH 4/Ar mixtures by varying the gas flow ratio, the radio-frequency (rf) plasma power and the chamber pressure. Atomic force microscopy (AFM) results and surface topographies are discussed. Although the etching rate of the n-ZnO at an H2/CH4 flow rate of 100/0 sccm, a work pressure of 100 mTorr and an rf power of 300 W is lower than under any other conditions, the rms roughness of 43.78 nm is the highest, and supports the application of roughened transparent contact layer (TCL) in light-emitting diodes (LEDs). The dynamics associated with the high etching rate were highly efficient at an H2/CH4/Ar flow rate of 38/5/57 sccm, a work pressure of 150 mTorr and an rf power of 300 W. In addition, the ZnO with thermal annealing were studied. The slower etching rate of annealed n-ZnO is observed due to an increase the crystal quality of the ZnO films after thermal annealing which consists with the x-ray diffraction (XRD) results.

原文English
文章編號71350D
期刊Proceedings of SPIE - The International Society for Optical Engineering
7135
DOIs
出版狀態Published - 1 十二月 2008
事件Optoelectronic Materials and Devices III - Hangzhou, China
持續時間: 27 十月 200830 十月 2008

指紋 深入研究「Reactive ion etching of ZnO using the H<sub>2</sub>/CH<sub>4</sub> and H<sub>2</sub>/CH<sub>4</sub>/Ar mixtures」主題。共同形成了獨特的指紋。

  • 引用此