MR imaging of articular cartilage at 1.5T and 3.0T: Comparison of SPGR and SSFP sequences

P. R. Kornaat*, S. B. Reeder, S. Koo, J. H. Brittain, Hsin-Chieh Yu, T. P. Andriacchi, G. E. Gold

*Corresponding author for this work

研究成果: Article同行評審

108 引文 斯高帕斯(Scopus)

摘要

Objective: To compare articular cartilage signal-to-noise ratio (SNR), contrast-to-noise ratio (CNR), and thickness measurements on a 1.5 T and a 3.0 T magnetic resonance (MR) scanner using three-dimensional spoiled gradient recalled echo (3D-SPGR) and two 3D steady-state free precession (SSFP) sequences. Methods: Both knees of five volunteers were scanned at 1.5 T and at 3.0 T using a transmit-receive quadrature extremity coil. Each examination consisted of a sagittal 3D-SPGR sequence, a sagittal fat suppressed 3D-SSFP (FS-SSFP) sequence, and a sagittal Dixon 3D-SSFP sequence. For quantitative analysis, we compared cartilage SNR and CNR efficiencies, as well as average cartilage thickness measurements. Results: For 3D-SPGR, cartilage SNR efficiencies at 3.0 T increased compared to those at 1.5 T by a factor of 1.83 (range: 1.40-2.09). In comparison to 3D-SPGR, the SNR efficiency of FS-SSFP increased by a factor of 2.13 (range: 1.81-2.39) and for Dixon SSFP by a factor of 2.39 (range: 1.95-2.99). For 3D-SPGR, CNR efficiencies between cartilage and its surrounding tissue increased compared to those at 1.5 T by a factor of 2.12 (range: 1.75-2.47), for FS-SSFP by a factor 2.11 (range: 1.58-2.80) and for Dixon SSFP by a factor 2.39 (range 2.09-2.83). Average cartilage thicknesses of load bearing regions were not different at both field strengths or between sequences (P > 0.05). Mean average cartilage thickness measured in all knees was 2.28 mm. Conclusion: Articular cartilage imaging of the knee on a 3.0 T MR scanner shows increased SNR and CNR efficiencies compared to a 1.5 T scanner, where SSFP-based techniques show the highest increase in SNR and CNR efficiency. There was no difference between average cartilage thickness measurements performed at the 1.5 T and 3.0 T scanners or between the three different sequences.

原文English
頁(從 - 到)338-344
頁數7
期刊Osteoarthritis and Cartilage
13
發行號4
DOIs
出版狀態Published - 1 四月 2005

指紋 深入研究「MR imaging of articular cartilage at 1.5T and 3.0T: Comparison of SPGR and SSFP sequences」主題。共同形成了獨特的指紋。

引用此