Influence of design and operation parameters on bag-cleaning performance of pulse-jet baghouse

Hsin Chung Lu*, Chuen-Tinn Tsai

*Corresponding author for this work

研究成果: Article同行評審

35 引文 斯高帕斯(Scopus)

摘要

In this study, a filter test system with clean new fabric bags was used to measure the pulse pressure and acceleration of the filter bag. Fabric acceleration and pulse pressure were used as an index of bag-cleaning intensity. The jet pump curves, which relate the flow rate through the venturi to the average developed pressure by the venturi, were determined by the similar system. The intersection of the jet pump curve and the bag operating line, which relates the pressure drop to flow rate across the bag during pulse-jet cleaning, is the system operating point that was used to predict the average pulse pressure in the bag during pulse-jet cleaning. Experimental results of this study show that a higher pulse pressure can be achieved without the venturi at the top of the bag for bag materials with low resistance coefficient. For bags with higher resistance coefficients, higher pulse pressure is obtained with a venturi installed at the top of the bag. The predicted pressure values are in good agreement with experimental data. Dimensional analysis for jet pump performance was developed to reduce the experimental data. The results show that the jet pump curves obtained under different operating conditions can be reduced to the same nondimensional curve, which can be used to facilitate the design and operation of a pulse-jet cleaning system.

原文English
頁(從 - 到)583-591
頁數9
期刊Journal of Environmental Engineering
125
發行號6
DOIs
出版狀態Published - 1 一月 1999

指紋 深入研究「Influence of design and operation parameters on bag-cleaning performance of pulse-jet baghouse」主題。共同形成了獨特的指紋。

引用此