Effect of bump size on current density and temperature distributions in flip-chip solder joints

Wei Chih Kuan, S. W. Liang, Chih Chen*

*Corresponding author for this work

研究成果: Article同行評審

23 引文 斯高帕斯(Scopus)

摘要

Three dimensional thermo-electrical analysis was employed to simulate the current density and temperature distributions for eutectic SnAg solder bumps with shrinkage bump sizes. It was found that the current crowding effects in the solder were reduced significantly for smaller solder joints. Hot-spot temperatures and thermal gradient were increased upon reducing the solder. The maximum temperature for solder joint with 144.7 μm bump height is 103.15 °C which is only 3.15 °C higher than the substrate temperature due to Joule heating effect. However, upon reducing the bump height to 28.9 μm, the maximum temperature in the solder increased to 181.26 °C. Serious Joule heating effect was found when the solder joints shrink. The higher Joule heating effect in smaller solder joints may be attributed to two reasons, first the increase in resistance of the Al trace, which is the main heating source. Second, the average and local current densities increased in smaller bumps, causing higher temperature increase in the smaller solder bumps.

原文English
頁(從 - 到)544-550
頁數7
期刊Microelectronics Reliability
49
發行號5
DOIs
出版狀態Published - 1 五月 2009

指紋 深入研究「Effect of bump size on current density and temperature distributions in flip-chip solder joints」主題。共同形成了獨特的指紋。

引用此