CFD analysis and experimental verification on a new type of air-cooled heat sink for reducing maximum junction temperature

Wen Xiao Chu, Ming Kun Tsai, Shun Yuan Jan, Hsiang Ho Huang, Chi Chuan Wang*

*Corresponding author for this work

研究成果: Article同行評審

5 引文 斯高帕斯(Scopus)

摘要

This paper investigates a new type of plate-fin heat sink having a rectangular fin-cut at the entrance while containing a fin-protrusion part at the rear of the heat sink. The design not only offers appreciable heat transfer enhancement without pressure drop penalty, but also pronouncedly reduces the maximum junction temperature (Tmax). It is experimentally validated that the effective thermal resistance can be reduced by 5.5–7.2% under the heating load of 250 W, and the temperature at the rear heat source can be reduced by about 2.5 K under same pumping power compared to the original plate-fin heat sink. Triangular fin-protrusion applying at the rear part shows more pronounced improvement on thermal performance compared to a rectangular one because of better heat spreading. Meanwhile, by placing a partition baffle below the rectangular fin-cut can further reduce the Tmax to reach as low as 354.5 K under the pumping power of 0.3 W. The effect of partition baffle and fin angle (θ) is quantitatively studied in more details. When θ is increased over 45°, the partition baffle shows further improvement on Tmax at fixed pumping power. The lowest Tmax is obtained when the fin angle (θ) of the fin-protrusion area reaches 65° It is also observed that the rectangular fin-cut is superior to a triangular one, suggesting a “Coanda-like” effect. In addition, a correlation is developed to predict the Tmax of the new air-cooled heat sink. The predictive deviations of the correlation against numerical results are within ±2.0 K, showing a reasonably predictive ability.

原文English
文章編號119094
期刊International Journal of Heat and Mass Transfer
148
DOIs
出版狀態Published - 二月 2020

指紋 深入研究「CFD analysis and experimental verification on a new type of air-cooled heat sink for reducing maximum junction temperature」主題。共同形成了獨特的指紋。

引用此