An experimental investigation of air cooling thermal module using various enhancements at low Reynolds number region

Kai Shing Yang, Shu Lin Li, Ing Youn Chen, Kuo Hsiang Chien, Robert Hu, Chi-Chuan Wang*

*Corresponding author for this work

研究成果: Article同行評審

33 引文 斯高帕斯(Scopus)

摘要

This study examines the airside performance of heat sinks having fin patterns of plate fin (Type I), interrupted fin geometry (Type II), dense vortex generator (Type III), and loose vortex generator (Type IV). Test results indicate that the heat transfer performance is strongly related to the arrangement of enhancements. The interrupted and dense vortex generator configurations normally contribute more pressure drop penalty than improvements of heat transfer. This is especially pronounced when operated at a lower frontal velocity. Actually the plain fin geometry outperforms most of the enhanced fin patterns such as of Type II and Type III at the fully developed region. This is because a close spacing prevents the formation of vortex, and the presence of interrupted surface may also suffer from the degradation by constriction of conduction path. The results suggest that the vortex generators operated at a higher frontal velocity is more beneficial than that of plain fin geometry. In association with the VG-1 criteria (same pumping power and same heat transfer capacity), the results show that effective reduction of surface area can be achieved when the frontal velocities are at 3-5 m s-1 and the fin patterns are triangular, triangular attack, or two-groups dimple. The result from the present experiment suggests that the asymmetric combination such as using loose vortex generator (Type IV) can be quite effective. The triangular attack vortex generator is regarded as the optimum enhancement design for it could reduce 12-15% surface area at a frontal velocity around 3-5 m s -1. The asymmetric design is still applicable even when the fin pitch is reduced to 1 mm.

原文English
頁(從 - 到)5675-5681
頁數7
期刊International Journal of Heat and Mass Transfer
53
發行號25-26
DOIs
出版狀態Published - 1 十二月 2010

指紋 深入研究「An experimental investigation of air cooling thermal module using various enhancements at low Reynolds number region」主題。共同形成了獨特的指紋。

引用此