A new configuration for ring resonator is proposed for bandpass filter design with size reduction and stopband extension. The planar self-coupled ring is twisted at its middle and a short CPW section is implemented in the ground plane for the three-dimensional interconnection. The resonator has two resonance modes and the filter possesses one transmission zero on the high side of the passband. With a pair of open low-impedance stubs attached to the ring, the circuit has an area of only 9.65% of that of the conventional ring resonator filter, and the upper stopband is extended up to higher than five times the center frequency. Measured results of a fabricated prototype circuit show good agreement with the simulation.
|State||Published - 2013|
|Event||IEEE MTT-S International Microwave Symposium Digest (IMS) - Seattle, United States|
Duration: 2 Jun 2013 → 7 Jun 2013
|Conference||IEEE MTT-S International Microwave Symposium Digest (IMS)|
|Period||2/06/13 → 7/06/13|
Lin, T-W., Kuo, J. T., & Chung, S-J. (2013). New Miniaturized Ring Resonator Bandpass Filter With Wide Upper Stopband. Paper presented at IEEE MTT-S International Microwave Symposium Digest (IMS), Seattle, United States. https://doi.org/10.1109/MWSYM.2013.6697738